[Federal Register: March 20, 1998 (Volume 63, Number 54)]
[Proposed Rules]               
[Page 13570-13572]
From the Federal Register Online via GPO Access [wais.access.gpo.gov]
[DOCID:fr20mr98-38]

-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

Federal Aviation Administration

14 CFR Part 39

[Docket No. 98-NM-15-AD]
RIN 2120-AA64

 
Airworthiness Directives; Airbus Model A319, A320, and A321 
Series Airplanes

AGENCY: Federal Aviation Administration, DOT.

ACTION: Notice of proposed rulemaking (NPRM).

-----------------------------------------------------------------------

SUMMARY: This document proposes the adoption of a new airworthiness 
directive (AD) that is applicable to certain Airbus Model A319, A320, 
and A321 series airplanes. This proposal would require replacing 
certain toilet rinse valves with modified rinse valves. This proposal 
is prompted by issuance of mandatory continuing airworthiness 
information by a foreign civil airworthiness authority. The actions 
specified by the proposed AD are intended to prevent water 
contamination of the avionics computers, which could result in the 
display of erroneous or misleading information to the flightcrew, and 
consequent reduced controllability of the airplane.

DATES: Comments must be received by April 20, 1998.

ADDRESSES: Submit comments in triplicate to the Federal Aviation 
Administration (FAA), Transport Airplane Directorate, ANM-114, 
Attention: Rules Docket No. 98-NM-15-AD, 1601 Lind Avenue, SW., Renton, 
Washington 98055-4056.

[[Page 13571]]

Comments may be inspected at this location between 9:00 a.m. and 3:00 
p.m., Monday through Friday, except Federal holidays.
    The service information referenced in the proposed rule may be 
obtained from Airbus Industrie, 1 Rond Point Maurice Bellonte, 31707 
Blagnac Cedex, France. This information may be examined at the FAA, 
Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, 
Washington.

FOR FURTHER INFORMATION CONTACT: Norman B. Martenson, Manager, 
International Branch, ANM-116, FAA, Transport Airplane Directorate, 
1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 
227-2110; fax (425) 227-1149.

SUPPLEMENTARY INFORMATION:

Comments Invited

    Interested persons are invited to participate in the making of the 
proposed rule by submitting such written data, views, or arguments as 
they may desire. Communications shall identify the Rules Docket number 
and be submitted in triplicate to the address specified above. All 
communications received on or before the closing date for comments, 
specified above, will be considered before taking action on the 
proposed rule. The proposals contained in this notice may be changed in 
light of the comments received.
    Comments are specifically invited on the overall regulatory, 
economic, environmental, and energy aspects of the proposed rule. All 
comments submitted will be available, both before and after the closing 
date for comments, in the Rules Docket for examination by interested 
persons. A report summarizing each FAA-public contact concerned with 
the substance of this proposal will be filed in the Rules Docket.
    Commenters wishing the FAA to acknowledge receipt of their comments 
submitted in response to this notice must submit a self-addressed, 
stamped postcard on which the following statement is made: ``Comments 
to Docket Number 98-NM-15-AD.'' The postcard will be date stamped and 
returned to the commenter.

Availability of NPRMs

    Any person may obtain a copy of this NPRM by submitting a request 
to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules 
Docket No. 98-NM-15-AD, 1601 Lind Avenue, SW., Renton, Washington 
98055-4056.

Discussion

    The Direction Generale de l'Aviation Civile (DGAC), which is the 
airworthiness authority for France, notified the FAA that an unsafe 
condition may exist on certain Airbus Model A319, A320, and A321 series 
airplanes. The DGAC advises that it has received a report indicating 
that water can leak from the rinse valve of the forward lavatory toilet 
bowl, and flow down into the flight compartment and possibly onto the 
avionics computers during nose-down maneuvers. The rinse valve can 
malfunction in such a way that it allows contaminated waste and 
corrosion to build up on the inside of the valve, which can allow water 
to overflow from the toilet bowl and onto the avionics computers. This 
condition, if not corrected, could result in the display of erroneous 
or misleading information to the flightcrew, and reduced consequent 
controllability of the airplane.

Explanation of Relevant Service Information

    Airbus has issued Service Bulletin A320-38-1049, dated January 22, 
1997, which describes procedures for replacing certain Monogram toilet 
rinse valves with modified rinse valves. The modification consists of 
installation of improved armature elbow assemblies in the rinse valves. 
Accomplishment of the actions specified in the service bulletin is 
intended to adequately address the identified unsafe condition. The 
Airbus service bulletin references Monogram Sanitation Service Bulletin 
15800-38-06A, Revision 2, dated July 7, 1997, as an additional source 
of service information.
    The DGAC classified Airbus Service Bulletin A320-38-1049, dated 
January 22, 1997, as mandatory and issued French airworthiness 
directive 97-269-103(B), dated September 24, 1997, in order to assure 
the continued airworthiness of these airplanes in France.

FAA's Conclusions

    These airplane models are manufactured in France and are type 
certificated for operation in the United States under the provisions of 
section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and 
the applicable bilateral airworthiness agreement. Pursuant to this 
bilateral airworthiness agreement, the DGAC has kept the FAA informed 
of the situation described above. The FAA has examined the findings of 
the DGAC, reviewed all available information, and determined that AD 
action is necessary for products of this type design that are 
certificated for operation in the United States.

Explanation of Requirements of Proposed Rule

    Since an unsafe condition has been identified that is likely to 
exist or develop on other airplanes of the same type design registered 
in the United States, the proposed AD would require accomplishment of 
the actions specified the Airbus service bulletin described previously.

Cost Impact

    The FAA estimates that 16 airplanes of U.S. registry would be 
affected by this proposed AD, that it would take approximately 6 work 
hours per airplane to accomplish the proposed actions, and that the 
average labor rate is $60 per work hour. Required parts would be 
provided by the manufacturer at no cost to the operators. Based on 
these figures, the cost impact of the proposed AD on U.S. operators is 
estimated to be $5,760, or $360 per airplane.
    The cost impact figure discussed above is based on assumptions that 
no operator has yet accomplished any of the proposed requirements of 
this AD action, and that no operator would accomplish those actions in 
the future if this AD were not adopted.

Regulatory Impact

    The regulations proposed herein would not have substantial direct 
effects on the States, on the relationship between the national 
government and the States, or on the distribution of power and 
responsibilities among the various levels of government. Therefore, in 
accordance with Executive Order 12612, it is determined that this 
proposal would not have sufficient federalism implications to warrant 
the preparation of a Federalism Assessment.
    For the reasons discussed above, I certify that this proposed 
regulation (1) is not a ``significant regulatory action'' under 
Executive Order 12866; (2) is not a ``significant rule'' under the DOT 
Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); 
and (3) if promulgated, will not have a significant economic impact, 
positive or negative, on a substantial number of small entities under 
the criteria of the Regulatory Flexibility Act. A copy of the draft 
regulatory evaluation prepared for this action is contained in the 
Rules Docket. A copy of it may be obtained by contacting the Rules 
Docket at the location provided under the caption ADDRESSES.

List of Subjects in 14 CFR Part 39

    Air transportation, Aircraft, Aviation safety, Safety.

[[Page 13572]]

The Proposed Amendment

    Accordingly, pursuant to the authority delegated to me by the 
Administrator, the Federal Aviation Administration proposes to amend 
part 39 of the Federal Aviation Regulations (14 CFR part 39) as 
follows:

PART 39--AIRWORTHINESS DIRECTIVES

    1. The authority citation for part 39 continues to read as follows:

    Authority: 49 U.S.C. 106(g), 40113, 44701.


Sec. 39.13  [Amended]

    2. Section 39.13 is amended by adding the following new 
airworthiness directive:

Airbus: Docket 98-NM-15-AD.

    Applicability: Model A319, A320, and A321 series airplanes; 
equipped with Monogram rinse valves having part number (P/N) 15800-
348, Revision C; and on which Airbus Modification 26145 (reference 
Airbus Service Bulletin A320-38-1049) has not been accomplished; 
certificated in any category.

    Note 1: This AD applies to each airplane identified in the 
preceding applicability provision, regardless of whether it has been 
otherwise modified, altered, or repaired in the area subject to the 
requirements of this AD. For airplanes that have been modified, 
altered, or repaired so that the performance of the requirements of 
this AD is affected, the owner/operator must request approval for an 
alternative method of compliance in accordance with paragraph (b) of 
this AD. The request should include an assessment of the effect of 
the modification, alteration, or repair on the unsafe condition 
addressed by this AD; and, if the unsafe condition has not been 
eliminated, the request should include specific proposed actions to 
address it.

    Compliance: Required as indicated, unless accomplished 
previously.
    To prevent water contamination of the avionics computers, which 
could result in the display of erroneous or misleading information 
to the flightcrew, and consequent reduced controllability of the 
airplane, accomplish the following:
    (a) Within 12 months after the effective date of this AD, 
replace all Monogram toilet rinse valves having P/N 15800-348, 
Revision C, with modified rinse valves in accordance with Airbus 
Service Bulletin A320-38-1049, dated January 22, 1997.
    (b) An alternative method of compliance or adjustment of the 
compliance time that provides an acceptable level of safety may be 
used if approved by the Manager, International Branch, ANM-116, FAA, 
Transport Airplane Directorate. Operators shall submit their 
requests through an appropriate FAA Principal Maintenance Inspector, 
who may add comments and then send it to the Manager, International 
Branch, ANM-116.

    Note 2: Information concerning the existence of approved 
alternative methods of compliance with this AD, if any, may be 
obtained from the International Branch, ANM-116.

    (c) Special flight permits may be issued in accordance with 
sections 21.197 and 21.199 of the Federal Aviation Regulations (14 
CFR 21.197 and 21.199) to operate the airplane to a location where 
the requirements of this AD can be accomplished.

    Note 3: The subject of this AD is addressed in French 
airworthiness directive 97-269-103(B), dated September 24, 1997.

    Issued in Renton, Washington, on March 13, 1998.
Darrell M. Pederson,
Acting Manager, Transport Airplane Directorate, Aircraft Certification 
Service.
[FR Doc. 98-7224 Filed 3-19-98; 8:45 am]
BILLING CODE 4910-13-U